porno izle - escort bayan istanbul
bahis casino siteleri

Configure Cisco Router to Send Messages to Remote Syslog Server

Posted June 13, 2006 by Quinn McHenry in Cisco router

Last Updated on

Centralizing log messages to a syslog server can improve the manageability of any size network and can decrease response times to resolve problems. Sending router log messages to a remote server also allows longer archiving of messages than in a router’s limited storage. Messages stored by syslog have permanence that a router does not. When a router is reloaded or power cycled, the messages in its log are erased. This tech-recipe describes the configuration steps required to make a router send messages to a remote syslog server.

To send messages to the syslog server at, use this command from enable mode:

conf t

The remote server must, of course, be configured to act as a syslog server and accept messages from the router.


About Quinn McHenry

Quinn was one of the original co-founders of Tech-Recipes. He is currently crafting iOS applications as a senior developer at Small Planet Digital in Brooklyn, New York.
View more articles by Quinn McHenry

The Conversation

Follow the reactions below and share your own thoughts.

Leave a Reply